Web Mountain Technologies RUC-01 Uživatelská příručka stáhnout pdf (Strana 32)

Web Mountain Technologies Page 26

Triggers

This page allows the user to setup simple IF – THEN actions based upon

receiving a particular command, serial string, time of day, or other events. Some

examples would be IF <UPB received> THEN send another UPB command with

or without a delay, or IF <UPB received> THEN send an email.

In addition, the user can setup a Scheduled event from this page or cause a

received signal from one protocol to trigger sending a command to another

protocol. This is also how you setup Buttons for the embedded Control Panel.

NOTE: IF-THEN type UPB Triggers will not function if there is a Remote session

(using UPStart or some other remote access software) in progress. Scheduled

events will function at all times, even if a Remote session is in progress.

NOTE: The RUC will not trigger on a command it has sent unless the Echo

selection on that COM port is set to YES on the Device Configuration page.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 103 104

Žádné komentáře

Web Mountain Technologies RUC-01 Uživatelská příručka Strana 32